Reply To: How to run the routerview command for a single job?

#8831
admin
Member

Ansewer;

to see the txfiles for job chnx-cap-locy do this:

hvrrouterview -c locy myhub/pwd chnx
where -c locy identifies the specific capture location called locy

Or

hvrrouterview myhub/pwd chnx $HVR_CONFIG/router/myhub/chnx/loc_locy/loc_*/*.tx*

To see the txfiles for job chnx-integ-locy do this:

hvrrouterview -i locy myhub/pwd chnx
where -i locy identifies the specific integrate location

Or

hvrrouterview myhub/pwd chnx $HVR_CONFIG/router/chnx/loc_*/loc_locy/*.tx*

© 2020 HVR

Test drive Contact us