How to run the routerview command for a single job?

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #8829
    Herman Verheul
    Keymaster

    How to run the routerview command for a single job?

    Usually I run it like ‘hvrrouterview ‘ but there are cases where it would be great to specify jobs

    #8831
    admin
    Member

    Ansewer;

    to see the txfiles for job chnx-cap-locy do this:

    hvrrouterview -c locy myhub/pwd chnx
    where -c locy identifies the specific capture location called locy

    Or

    hvrrouterview myhub/pwd chnx $HVR_CONFIG/router/myhub/chnx/loc_locy/loc_*/*.tx*

    To see the txfiles for job chnx-integ-locy do this:

    hvrrouterview -i locy myhub/pwd chnx
    where -i locy identifies the specific integrate location

    Or

    hvrrouterview myhub/pwd chnx $HVR_CONFIG/router/chnx/loc_*/loc_locy/*.tx*

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

© 2020 HVR

Test drive Contact us